Ip camera tester3/29/2024 ![]() ◇ Do not use non-standard POE power supply and non-standard POE injector to recharge. Otherwise it may damage the tester. And the tester may automatically reset and even cause malfunction when battery runs out. ◇ If DC12V or PSE power output is applied when recharging, the output consumption can be higher than the input power supply, in that case, the battery can’t be recharged and even cause discharging. However, it’ll take a little longer to recharge when the tester is power-on. ◇ Recharging is available when tester is power-on and off. When battery is fully charged, the charge indicator will turn off. ◇ It will take 3~4 hours to recharging a fully run-out battery. When the yellow light of port 2 and the charge indicator turns on, the tester starts to recharge the battery. ![]() ![]() ◇ Connect POE injector output port to tester port 2 via a RJ45 cable. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |